HELP!:1976 Fender/Sho-Bud Needing to make longer Pedal Rods
Posted: 18 Mar 2011 12:55 pm
Hello, I need help from all you pedal steelers out there. I recently purchased a 1976 Sho-Bud built Fender Dual Neck, I don't know the exact model number. I am 6'4" and need longer rods. I called David Jackson and he told me the following instructions, Let me know if I am right.
1. Set the guitar up to my desired height without the Pedal Bar.
2. Set the pedal bar up at where it needs to be for optimum playing postion. Place a magazine under the pedals to set them in optimum playing position.
3. Measure from the Pedal Ball to the hole on the puller.
4. Cut your rod to 1/4" shorter than the above length.
5. Put your connectors on and Play!!
Let me know if this right guys!
Thanks,
Doug in El Paso
1. Set the guitar up to my desired height without the Pedal Bar.
2. Set the pedal bar up at where it needs to be for optimum playing postion. Place a magazine under the pedals to set them in optimum playing position.
3. Measure from the Pedal Ball to the hole on the puller.
4. Cut your rod to 1/4" shorter than the above length.
5. Put your connectors on and Play!!
Let me know if this right guys!
Thanks,
Doug in El Paso