Duncan Seymour Pickup Wiring?

Brian Henry · Posted 20 Nov 2010 10:35 am

I am putting a duncan semour hot rails pickup into a lap steel. I want to run the wires direct to a jack. There are 5 wires : red, white, green, black, and bare. Does any one have an idea which wires to combine into two so I have a good ground and hot. Many thanks Brian
_________________
LOOKOUT MOUNTAIN GEORGIA

Tom Pettingill · From: California, USA (deceased)

Its a humbucker so would follow the typical SD wiring code

Red and white get soldered together and taped / shrink wrapped ... (these are only used when doing coil split wiring)
Bare and green to ground
Black is hot to tip
Here is a basic HB diagram for reference
http://www.seymourduncan.com/pdfs/support/schematics/1hum_1vol.pdf
_________________
Some misc pics of my hand crafted steels
Follow me on Facebook here

Brian Henry · Posted 20 Nov 2010 10:59 am

Thank you Tom for a speedy reply. Your steels are magnificent looking!
_________________
LOOKOUT MOUNTAIN GEORGIA

Forum Index > Steel Without Pedals		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: