| Author |
Topic: Shobud vertical lever install |
Dennis Bailey
From:
Fort Worth Texas
|
Posted 15 Nov 2019 2:58 pm |
|
Greetings all,
I am installing a vertical knee lever on my '77 Loyd Green Model. It's going on the left knee.
The parts came from Micheal Yahl at psgparts.com.
Am wondering if anyone else has done this install?
Honestly, I could use some coaching before I go drilling holes in my LDG.
Will post some pics tomorrow.
Thanks |
|
|
|
Ian Worley
From:
Sacramento, CA
|
|
|
|
Dennis Bailey
From:
Fort Worth Texas
|
Posted 15 Nov 2019 4:38 pm
|
|
| Thanks Ian, checking it out now |
|
|
|
Kevin Fix
From:
Michigan, USA
|
Posted 15 Nov 2019 6:48 pm
|
|
Hers mine on a Super Pro. I installed mine also. I had to do a modification on mine so the lever would be low enough to make it work for me.
 |
|
|
|
Dennis Bailey
From:
Fort Worth Texas
|
Posted 17 Nov 2019 5:25 am
|
|
Thanks Kevin,
I finished the install. Had to cut 1/4" off of the cross shaft so it would clear the knee lever next to it. Also, the connector with the two swivel connectors had to be cut and one end tapped, to get the length to be correct. (finally got to use the tap and die set my Dad left me). It took a few adjustments but now its working well.
Michael Yahl was very helpful in getting the parts!. On the tear drop levers he sells, there is a small allen screw for height adjustment. The original levers on this Guitar don't have them. Here is a before and after pic.
Last edited by Dennis Bailey on 18 Nov 2019 2:49 am; edited 1 time in total |
|
|
|
Dick Sexton
From:
Greenville, Ohio
|
Posted 17 Nov 2019 6:31 am Very nice!
|
|
| Nice clean install. |
|
|
|
Dennis Bailey
From:
Fort Worth Texas
|
Posted 18 Nov 2019 2:47 am
|
|
Thanks Dick,
It was fun. The actual install went pretty quick...but it took hours of placing the parts in different scenarios and to finally decide where everything went. Here is a pic of the cross shaft.
 |
|
|
|
