Chuck Snider R.I.P.
From:
West Virginia, USA - Morgantown, WV
|
Posted 7 Apr 2009 7:11 am |
|
Hi John, welcome to the world of Pedal Steel Guitar (PSG)!!! Use this forum as much as you can to ask questions (and there are no dumb ones) and get advice. This forum is invaluable to newbies. I am still a newbie as well.
To answer your question, I assume you have a pedal steel guitar?? although the this would apply to lap steel as well, assuming you have a pedal for it. the connections would be:
Guitar--->volume pedal--->reverb/delay unit--->amp
Looking at a picture of that particular unit online, it appears to have one input on the right side, and two outputs (A and B) on the left side, in your case you would use output A for mono. If you had two amps you could use A and B for a stereo effect.
You did not mention what sort of amp you have, some allow you to connect effects boxes via an effects out and effects return.
I would think there would have been a small and brief sheet of instructions which would also describe typical connection scenario.
By the way, here is a link to the Behringer site and specifically the user guide document: http://www.behringerdownload.de/DR400/IMPL%20Tech%20GLOB_P0534_M%20Web%20EN_2007-12-18_Rev.2.pdf
Although, it doesn't seem to have details on connections.
I hope that helped some??
-Chuck
_________________
GFI U-12 Ultra Keyless, Carter Black U-12, both with Alumitones, and a sweet '70 Sho-Bud Permanent D-10, NV400 in Rick Johnson cabs, NV112, '73 Vibrosonic in Rick Johnson cabs, Hilton pedal, Steeler's Choice seat, Bessdang Gizmos from Dale Hansen, and a few other widgets and doodads.
I may not sound good, I just don't wanna sound bad. |
|
