The Steel Guitar Forum

I've seen what loks like plastic piping attached to a steel's leg to hold an effect. Does anybody know what to use? It shure would save me some experimenting. I used a bicycle light holder as a mount yers ago.
Thanks for your help.
Bill CArroll haddonbc@verizon.net

Billy Cooper's Music in Orange,Va. sells these in two different sizes.

Go down to your local plmbing/hardware store and get a section of schedule 40 (the gray colored one).Works fine and last a long time. All you need is a hack saw, file and drill.

1/2" PVC with the "T" notched to snap in place, the inner ring that keeps the pipe from going in too far has to be removed.I used a cross T that I sanded a flat side on a belt sander, added velcro so tuner can be used. Don't use glue so it can be adjusted. Also have made cup holders,and bar holders Bill

Bill, can you turn that T so it will support this on a PSG for us old folks
PVC for I V

Bo,
I think it will work OK if you insert a hook, and lie on the floor to facilitate a flow.

Bill ....AKA Dr. BUBBER