| Author |
Topic: Problem tuning 2nd string |
Charlie Thompson
From:
South Carolina, USA
|
Posted 4 Dec 2008 6:38 am |
|
| I tune to Eb open, lower RKR to C# and tune the nylon hex all looks good, but the string returns flat. It returns slightly less flat when I tune the the D split. String 9 also lowers D to C# and its ok. GFI Ultra S-10. Any Ideas? Thanks |
|
|
|
CrowBear Schmitt
From:
Ariege, - PairO'knees, - France
|
Posted 4 Dec 2008 7:16 am
|
|
click on this Charlie & look up " feel stop "
it's the proper procedure in tuning that 2nd string lower in conjunction w: string 9 lower
the second string half stop lower ( eb to d) is tuned w: the nylon tuner on string 9
http://www.mountainbiofuel.com/zumsteel/ZumSteel_Manual.pdf
i hope this is will sort you out otherwise another fo'bro will undoubtedly,jump in & help you along |
|
|
|
Joseph Barcus
From:
Volga West Virginia
|
Posted 4 Dec 2008 10:06 am
|
|
sometimes when you run into that problem it may be adjusted to far in I would try first to back the nylon all the way back where you know its not against the changer, and also back any others that are used on the knee until you know its not against the changer then start over I bet you have one in too far
_________________
https://www.youtube.com/channel/UCvuH7H8BajODaL_wy3_HSJQ |
|
|
|
Charlie Thompson
From:
South Carolina, USA
|
Posted 4 Dec 2008 11:08 am
|
|
| Thanks guys I'll check out both |
|
|
|
