Page 1 of 1
K-nuts
Posted: 4 Sep 2008 6:23 am
by Larry Hillman
i am using an 8-string home brew steel. (not lap)only 1 problem, with the bone nut i am using, strings
10/14&17 vibrate into the nut making them lower.
Help Needed.
Posted: 4 Sep 2008 7:51 am
by Brad Bechtel
When you say "vibrate into the nut making them lower", are you talking about the strings buzzing where they are seated in the nut? That usually means the slot for the string is too wide for the string gauge being used.
If you're talking about something else, please explain better. Thanks.
Posted: 4 Sep 2008 8:50 am
by Bill Creller
Stewart-MacDonald has nut files in various gauges, which may help get the strings seated in the nut.
Posted: 7 Sep 2008 8:08 pm
by Dom Franco
If the nut is plastic or bone you can place a small drop of super glue in the groove and when it's dry try the string again, if it's still buzzing, repeat as often as needed. You can also use an exacto saw blade or jewelers file on the hardened superglue as needed.
Dom
