Page 1 of 1
Walwarts in Australia ???
Posted: 24 Sep 2007 11:50 pm
by Brendan Mitchell
I bought a Peavey effects unit from a forum member { no problem good deal good service } the walwart says it runs off 120v 60hz and produces 16v at 1100 mA . My power supply is 240v 50hz . Any suggestions ? I have not plugged it in to try . Do I have to try and sell it back to someone in USA ?
Posted: 25 Sep 2007 2:54 am
by Brendan Mitchell
Futher to my question , I have located a unit that will output 16v DC at 1.25 amps . My Peavey Delta Stomp calls for 16v at 1. amp . Do you think this is close enough ?
Posted: 25 Sep 2007 12:46 pm
by Paddy Long
Brendon that should work just fine ...the 230V - 16V walwarts are hard to come by in this neck of the woods - it should work with your peavey unit without any issues.
Posted: 26 Sep 2007 2:50 am
by Brendan Mitchell
Thanks Paddy I'll give it a go .
Posted: 26 Sep 2007 4:16 am
by Ian Ellis
Brendon
If it's DC you are working with make sure you connect +ve from the power supply to +ve on the stomp box. Sometimes the output plugs on power supplies can be reversed.
Posted: 26 Sep 2007 4:33 pm
by Brendan Mitchell
Could you explain that more please Ian ? Does that mean the centre pin is + or - ?
Posted: 27 Sep 2007 5:26 am
by Ian Ellis
Brendon
Hope I didn't confuse you. The centre is normally +ve however there are some instances where it is the other way around. If the power supply you are using is designed for your stomp box you won't have a problem. If you have any doubt I suggest you get someone to measure the voltage from the power supply to determine its polarity.