Posted: 23 Feb 2005 4:19 pm
If you're looking for top-notch, fine-grit finishing paper, try: https://www.micro-surface.com/. Washable, reusable papers up to 3200 grit. Should take you right up to a "buff" quality finish.
The Steel Guitar Forum
where steel players meet online
https://leylines.no-ip.org/
Aluminum swirl marks
Page 2 of 2
Posted: 23 Feb 2005 5:20 pm
I would not do any polishing until you have removed all the strings and roller nuts and somehow covered the cabinet because the dust from sanding will get all over it and into the mechanics, also polish will coat the strings when you buff making them go dead, this happened to me on my U12 MSA so prep your guitar before you begin. steveb.
Posted: 24 Feb 2005 10:23 am
Look for SimiChrome polish at your local motorcycle shop. They usually have it at Harley dealers.
(Edit: D'oh! Didn't see the earlier post!)
Try the SimiChrome first. I wouldn't go the wet sanding route unless you are really talking "scratches"; you're just getting into a whole lot of work. Light swirl marks should polish out with a couple of applications of SimiChrome.
------------------
<FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by Mark Herrick on 24 February 2005 at 10:25 AM.]</p></FONT>
(Edit: D'oh! Didn't see the earlier post!)
Try the SimiChrome first. I wouldn't go the wet sanding route unless you are really talking "scratches"; you're just getting into a whole lot of work. Light swirl marks should polish out with a couple of applications of SimiChrome.
------------------
<FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by Mark Herrick on 24 February 2005 at 10:25 AM.]</p></FONT>