| Author |
Topic: Session 400 repair in No. Cal. |
Paul Sutherland
From:
Placerville, California
|
Posted 22 Jun 2007 12:06 am |
|
| Who do you recommend to repair a Session 400 in northern California, the closer to Sacramento the better? |
|
|
|
David Wright
From:
Pilot Point ,Tx USA.
|
Posted 29 Jun 2007 5:25 am
|
|
| try Skips Music in Sac... or just send it to Peavey.... |
|
|
|
Jay Fagerlie
From:
Lotus, California, USA
|
Posted 30 Jun 2007 7:04 am
|
|
What's wrong with it, Paul?
Jay |
|
|
|
Paul Sutherland
From:
Placerville, California
|
Posted 30 Jun 2007 5:18 pm
|
|
Jay,
It seems that I shorted something out. The amp suddenly just had a loud hum/buzz. I suspect that when I put the new pot in my Emmons volume pedal I left a little too much solder on one post as it appears to have touched the side of the pedal. I have taken the amp to Rainbow Electronics in Sacramento. They are the Peavey authorized repair site in this area, and I have used them before to repair the reverb unit. I was just looking for another option because Rainbow was a bit expensive and took quit awhile to complete the last repair.
Should I be considering some sort of mod while the amp in on the bench. This is a late 70's session 400 that always worked flawlessly until I stopped playing professionally back in the early 80's. Since then it has mostly sat in the garage, and now it has these issues. Thanks for your replies. Paul |
|
|
|
