| Author |
Topic: power cord for Fender Steel King |
Bob Miano
From:
Bergenfield, N.J. (home of "some" country music) - deceased
|
Posted 30 May 2007 5:57 pm |
|
Apparently left my power cord at a gig (can't seem to find it).
I ended up with a computer power cord to replace it. It seems to be
fine, but not the same cord that came with the amp.
Will I run into any problems using this replacement cord or should I get
one designed for the Fender Steel King's power?
No clue on these electronic things......
Thanks for your help,
Bob Miano |
|
|
|
Kevin Mincke
From:
Farmington, MN (Twin Cities-South Metro) USA
|
Posted 30 May 2007 6:10 pm
|
|
| Bob, the power cord your using will be fine as a replacement. It sounds like it's a standard poer cord that is commonly found on newer amps using the computer/monitor type power cord. It's a "universal" but I forget what the technical name is. |
|
|
|
Jonathan Cullifer
From:
Gallatin, TN
|
Posted 30 May 2007 7:43 pm
|
|
| It's an IEC C13 power cable (into an IEC C14 jack) and it's more than adequate to handle the current draw of the amp. |
|
|
|
Tommy R. Butler
From:
Nashville, Tennessee
|
Posted 30 May 2007 8:18 pm
|
|
| I broke the ground off my Nashville 112 and replaced it with a real heavy duty chord. Man I can actually tell a difference in sound when I plug it strait into the wall and not use a extension chord. Weird.!!! |
|
|
|
Bob Miano
From:
Bergenfield, N.J. (home of "some" country music) - deceased
|
Posted 31 May 2007 10:26 am
|
|
Thanks for the help,
Bob |
|
|
|
