Help with Sonar
Moderator: Shoshanah Marohn
-
- Posts: 469
- Joined: 17 Aug 1999 12:01 am
- Location: Fairfield, Ohio
Help with Sonar
I'm using Sonar 4 Producer edition with a Sound Blaster Audigy2 ZS Platinum card. I use BIAB to make rhythm tracks and Power Tracks 10 to edit and load individual tracks into Sonar. When I record steel onto a seperate track I get the rhythm section recorded also to the track that i just recorded. Is there a setting in sonar that I'm missing to check. I've used Magix Studio in the past and didn't have this problem. What do I need to alleviate this problem? An Audio Interface? Any help greatly appreciated. Thanks Eddie
- Robert Leaman
- Posts: 585
- Joined: 21 Feb 2006 1:01 am
- Location: Murphy, North Carolina, USA
-
- Posts: 469
- Joined: 17 Aug 1999 12:01 am
- Location: Fairfield, Ohio
- David L. Donald
- Posts: 13696
- Joined: 17 Feb 2003 1:01 am
- Location: Koh Samui Island, Thailand
- Contact:
If you had the sub mix going to tracks 1 & 2,
and then added another track to record the steel,
but IT was being fed by buss 1 or 2 also.
What ever you send to it will be recorded also.
So if you are mixing to 1+2, use 3, 4 ,5 ,6 etc.
for your single instrument send.
Also if you send effects sends out and they go to a buss,
then THEY will comeout with anything you send to it.
ei. make sure ONLY your choosen track
is sending to a record buss.
and then added another track to record the steel,
but IT was being fed by buss 1 or 2 also.
What ever you send to it will be recorded also.
So if you are mixing to 1+2, use 3, 4 ,5 ,6 etc.
for your single instrument send.
Also if you send effects sends out and they go to a buss,
then THEY will comeout with anything you send to it.
ei. make sure ONLY your choosen track
is sending to a record buss.
-
- Posts: 469
- Joined: 17 Aug 1999 12:01 am
- Location: Fairfield, Ohio