Hi Everyone... I know this an old subject. What is the right way to do this 3 cord hookup.. I have a Goodrich passive pedal. It has 1 jack for Inst. and 2 jacks for amp. I hooked a cord from the Inst.jack to the send jack on the amp and a cord going from the amp jack to the return jack on the amp. Is this the right or should they be reversed.. Both amps are Peaveys N-12 and a N1000. Thanks for the help.. You learn alot on this forum.Everyone is great..
------------------
Bryan Ainsworth
3 cord Vol Pedal Hookup
Moderator: Shoshanah Marohn
-
Brian Ainsworth
- Posts: 13
- Joined: 1 May 2006 12:01 am
- Location: Fishkill New York
-
Mike Wheeler
- Posts: 3058
- Joined: 18 Oct 2004 12:01 am
- Location: Delaware, Ohio, USA
On the front of the N112 you have a Pre-EQ patch. I use that one.
From guitar output go directly to the N112's input jack (on the left). From the Pre-EQ patch OUT jack go into the pedal's input (where you'ld normally plug the guitar). Then out of the pedal's output (either one) into the Pre-EQ patch IN. That's it.
From guitar output go directly to the N112's input jack (on the left). From the Pre-EQ patch OUT jack go into the pedal's input (where you'ld normally plug the guitar). Then out of the pedal's output (either one) into the Pre-EQ patch IN. That's it.
-
Brian Ainsworth
- Posts: 13
- Joined: 1 May 2006 12:01 am
- Location: Fishkill New York