Sessions 400

Bill Crook · From: Goodlettsville, TN , Spending my kid's inheritance

This is for all you techie-type guys.

I am in the process of makeing a pictorial layout of the "Sessions 400" amp. This is the older unit that has the 2 printed circuit boards.

The photo below is a sample of what it will look like. I haven't put all the componnets on it yet but this is only a sample of the Pre-amp and tone circuit. Note that the resistors are all 22k in the picture but this is for reference only. I will put in the correct values later.

If any of you guys think you would be interested in this,I will pursue it in a more speedy fashion otherwise, I'm gonna take my time with it.

Peavey "Sessions 400"

[This message was edited by Bill Crook on 01 March 2004 at 02:46 PM.]

Brad Sarno · From: St. Louis, MO USA

Great work Bill! You're our hero for doing this!

Brad Sarno

Bill Ford · From: Graniteville SC Aiken

Bill,
Would'nt it be quicker and easier to order one from Peavey.Only cost a couple $$ and takes two/three days.

Bill

Ken Fox · From: Nashville GA USA

Good job! Peavey never made one of these, I know I asked Mike Brown only recently. I would love to have one. I am in the midst of pulling my hair out trying to get rid of some noise on the power amp board in a Session 400, this would be a blessing to have.

[This message was edited by Ken Fox on 01 March 2004 at 05:28 PM.]

Mike Brown · From: Meridian, Mississippi USA

A pictorial layout of the '70's Session 400 did not exist on this model. Pictorials came in the early '80's.

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: