Patch Nash 400

Raul Huerta · From: Cuauhtemoc, Chihuahua, Mexico

Can Anyone tell how is the conection circuite of the output and input Patch for get the best sound of my guitar , I have a Nash 400, Ernie Ball Volumen Pedal & Boss DD-3 efects.

thanks friends.....Raul

Mike Brown · From: Meridian, Mississippi USA

Hello Raul,
I suggest that you use the 3 cord volume pedal hookup. The hookup is as follow; connect cable #1 direct from the output of your guitar to input #1 of the Nashville. Next, connect the second cable from the SEND jack to the input of your volume pedal. Using the third cable, connect from the output of your pedal to the RETURN jack in the PRE EQ PATCH section of the amp.

I would either try placing the DDL-3 between the guitar output and amp input, or use the backpanel PREAMP OUT and route to the input of the pedal, then using another shielded cable, connect from the output of the pedal to the POWER AMP IN on the rear panel of the amp.

Hope that this works for you.

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: