Sessions 500 settings

Ervin McMullen · Post by **Ervin McMullen** » 8 Mar 2002 4:53 pm

Can someone help me with settings for a Sessions 500 with Mod. Also where does the RV3 connect for the best result. I'm playing a 87 Emmons D10 PP. Thanks

gary darr · Post by **gary darr** » 8 Mar 2002 6:24 pm

My session doesnt have the mod so its hard for me to say on settings,allso your preference on tone may vary to others.I usually just try to get the amount of bottom first then bring in the highs and presence to balance it all out. I will say that I allways seem to get a better sound using the three cord pedal patch....good luck on your "tone quest"
PS when I do use out board reverb I use the pedal patch for it( effect is between vol pedal out and pedal in on the amp)this way the reverb continues to ring and decay even when your vol pedal is down or your strings are muted.I hope I explained this right..... Mike Brown where are you?....
------------------
Sho-Bud proII custom,Session 500,American standard Strat,Shecter tele,Peavy Classic 50,Fender Vibrolux

<FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by gary darr on 08 March 2002 at 06:35 PM.]</p></FONT>

Ervin McMullen · Post by **Ervin McMullen** » 8 Mar 2002 9:27 pm

Thanks for the advice. I'm going to try that.

Mike Brown · Post by **Mike Brown** » 11 Mar 2002 1:55 pm

Ervin,
I'm right here. Call me toll free at 1-877-732-8391 and let's discuss.

Mike Brown

Ervin McMullen · Post by **Ervin McMullen** » 11 Mar 2002 5:06 pm

Thanks Mike. I'll give you a call. It's a great amp - hopefully I can squeeze some of its potential out with my playing.

Ervin