StringMaster Neck Joining Tubes 3D Printed Check it Out !

George Piburn · From: The Land of Enchantment New Mexico

I saw a recent thread about the little tubes that are used in StringMaster to help out the threaded rods when joining 2 or more necks.

I took measurements from the below photo, Mrs.Boards does the CAD and 3D print software I do the 3D printing.

This is what we came up with to Help StringMasters "Live Again".

These might help with the Hudson - Gary Rue - StringMaster Styles they produce.

_________________
GeorgeBoards S8 Non Pedal Steel Guitar Instruments
Maker of One of a Kind Works of Art that play music too.
Instructional DVDs
YouTube Channel

Robert Allen · From: Tennessee, USA

Exactly what I'm going to be needing. Is this item listed on your web site yet? Bob Allen, Melbert Guitars.

George Piburn · From: The Land of Enchantment New Mexico

Thanks for your response, I was hoping to hear from the StringMaster salvage folks, this is even better an actual current maker.

Not on any of my web sales sites at this point. I am happy to sell these directly.

I have ones in the photos here if that is enough, and can print more.

The Material is called Tough PLA (polylaticacid) modern rugged, in their intended use , there should be little if any stress on them so durability seems to be in the high category.
_________________
GeorgeBoards S8 Non Pedal Steel Guitar Instruments
Maker of One of a Kind Works of Art that play music too.
Instructional DVDs
YouTube Channel

Forum Index > Steel Without Pedals		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: