Sold on another website.

[Justin Myers]

Sold on reverb.com

[Andy Taub]

What's the knob on the back? Would you say this is like a princeton reverb in volume/sound?

[gary pierce]

https://milkmansound.com/products/300w- ... f-and-half

[Justin Myers]

Bump

[Justin Myers]

Bump. Still for sale!

[Sonny Jenkins]

What does that unit weigh?

[Frank Canino]

PM sent.

[Jon Jaffe]

Sonny,

Head 16-1/2" W x 8" H x 7-1/2" D 12lbs

[Justin Myers]

Bump

[George Frachiseur]

PM Sent

[Rich Gibson]

Hi Justin I can’t quite make out the back of the amp
Is there 2 speaker outs?
Both 8 ohms?
Is the max power at 4 ohms?
300 watts at 4 ohms
150 at 8ohms
The manual doesn’t specify
Thanks

[Bill Hatcher]

What's the knob on the back? Would you say this is like a princeton reverb in volume/sound?

the knob is the output control for the line/preamp out. looks like it is 1/4" and an xlr for balanced.

in regards to this being like a princeton....this is a tube preamp section with a solid state power output section. it would not be anything like a princeton in regards to volume. from the info on the amp, it looks like the preamp section is driving the tubes at high voltage. this will be a totally different sound than most other hybrid tube pre/solid state power amps. most of those run off reduced voltage in the tube pre section so they wont have to have two separate power supplies or a circuit to achieve that.

looks like you can use the preamp section separate from the amp section for a stand alone preamp if needed.

[Justin Myers]

900 shipped! still for sale. thanks!