Hilton Sus

Ken Metcalf · From: San Antonio Texas USA

Hi Everybody
I bought a Hilton Sustainer and the tone knob spins 3/4 around and doesn't do much,
then has a spot that is very touchy.
I use this with a Hilton vol. ped.
Is this Touchy-ness same as you guys have found with yours ???

Ken Metcalf D-10 Carson Wells

Paul Norman · From: Washington, North Carolina, USA

It sounds like the set screw in the knob is
loose. I didnt think you needed a sustain with the hilton pedal. I thought it was built into the pedal electronically.
Keith Hilton will tell you.

Robert Porri · From: Windsor, Connecticut, USA

I bet this thread is on it's way to Electronics.

I'm certain Paul is correct about the Digital Sustain being part of the circuitry of the Hilton Volume Pedal already. Keith seems to verify that here http://steelguitarforum.com/Forum11/HTML/000848.html

Bob P.

[This message was edited by Robert Porri on 05 January 2006 at 08:45 PM.]

[This message was edited by Robert Porri on 05 January 2006 at 08:46 PM.]

Ken Metcalf · From: San Antonio Texas USA

I'm wondering if these units are not designed to work together.. sounds good though.. I sent K. Hilton this question

Ken Metcalf D-10 Carson Wells

Robert Porri · From: Windsor, Connecticut, USA

Ken,
Please followup with what Keith Hilton says. I'm always open for new information. I did wonder about this when I purchased my Hilton Volume Pedal also, and have been convinced that the volume pedal essentially already has the sustain "unit" in it and there would be no advantage to adding the separate sustain. I'd like to mention also what a pleasure Keith Hilton was to deal with. I'm sure you'll find this out also.

Bob P.

Donny Hinson · From: Glen Burnie, Md. U.S.A.

Forum Index > Pedal Steel		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: