Fender 800

[Al Risbeck]

Radically modified Fender 800, conversion to rods instead of cables but needs finished, for health reasons I can't finish it. if interested please call me at 303-901-1449 for answers.if it don't go like it is I will be parting out soon. $550.plus shipping


NOTE- The case shown in Picture was sold with another steel. the case I have to ship it in is and older case for shipping.

[Jack Goodson]

al, doe,s the levers work as they are or would all that have to be finished?....thanks jack

[Al Risbeck]

Jack left knee levers work, right knee one need to be re designed as there is too much travel required. All rods need redone and I’m my opinion timed with springs and collars like an Emmons p/p it will come with Emmons four hole bellcranks and swivels and other extras. All parts that needed it have been re-chrome, legs etc.

[Jack Goodson]

al, doe,s the pedals work as they should, and are they setup in emmon, also are the knee levers set up emmons with e,s on the left knee?....thanks jack

[Jack Goodson]

al, doe,s the levers work as they are or would all that have to be finished?....thanks jack

[Al Risbeck]

It is Emmons setup, pedals are about the same stiffness as a cable rig, right knee levers need re designed.

[Jon Zimmerman]

Countless hours put onto plans and fabricated components..at a giveaway dispossess is what I see. If you are any kind of ' knuckle-skinner' with half of Al's resolve inside you, this would be a short distance to complete. So sorry health issues have to interrupt, Al. I know that curse quite well. Best Wishes. Jon Z.

[Mike DiAlesandro]

Al,
I would like to buy it, I sent you an email.

[Al Risbeck]

SOLD pending payment