How do I re-position a pullrod?

Mitchell Blum · Post by **Mitchell Blum** » 4 Jun 2016 3:13 pm

I need to reduce the slack/change the action on my GFI pedals. Can anyone explain how to change the position of the pull rod at the pull bar and/or the changer fingers?

Mitchell Blum · Post by **Mitchell Blum** » 4 Jun 2016 4:23 pm

Wow. Maybe I'll just surgically lengthen my left leg . . .

Mitchell Blum · Post by **Mitchell Blum** » 4 Jun 2016 5:00 pm

Thanks for the prompt reply and encouragement I'll attempt it -- glad to have a trailblazer out there!

Thanks
Mitch

Lane Gray · Post by **Lane Gray** » 4 Jun 2016 5:19 pm

It looks dead easy.
Loosen screw, slide out rod (that's clever, having the rod hold the puller in), pop the puller out, move it to the new hole, slide the rod back in, tighten screw.

Mitchell Blum · Post by **Mitchell Blum** » 4 Jun 2016 7:26 pm

Too easy! No hole change. All that was needed was to (1) loosen ferrule screw (2) take up some slack in the rod (3) re-tighten and that was it.

Thanks guys,
Mitch