Not Sure What This is For...

Chris Weronski · Post by **Chris Weronski** » 6 Jul 2015 8:26 am

On the end of both necks where the bridge and pickups are, there are 2 hex or Allen screws (on each neck) that seem to raise or lower the neck at the end where your picking hand rests. Is there a name for this adjustment? Also, what is the reason that you would want to make this adjustment? I haven't been able to find any information about it. The guitar is a 1979 Sho-Bud Super Pro.

chris ivey · Post by **chris ivey** » 6 Jul 2015 8:33 am

i would doubt that it raises the neck. it might secure the neck.

Jim Eaton · Post by **Jim Eaton** » 6 Jul 2015 9:51 am

Sounds like pick-up adjustment screws..

Dan Beller-McKenna · Post by **Dan Beller-McKenna** » 6 Jul 2015 11:30 am

Those hold the bridge housing down; I wouldn't mess with them unless you are completely dissembling the guitar.

Martin Weenick · Post by **Martin Weenick** » 6 Jul 2015 11:48 am

Those are not allen screws, they are socket head machine screws and they hold the housing down. Do not fiddle with !!

Henry Matthews · Post by **Henry Matthews** » 6 Jul 2015 1:22 pm

Martin Weenick wrote:Those are not allen screws, they are socket head machine screws and they hold the housing down. Do not fiddle with !!

What's the difference Martin, I always though they were allen screws. Just courious.

chris ivey · Post by **chris ivey** » 6 Jul 2015 2:36 pm

chris ivey wrote:i would doubt that it raises the neck. it might secure the neck.

gee, i was right again!

Lane Gray · Post by **Lane Gray** » 6 Jul 2015 2:37 pm

I think they're still Allen head screws.

chris ivey · Post by **chris ivey** » 6 Jul 2015 2:39 pm

who cares? they hold the neck on! question answered.

Chris Weronski · Post by **Chris Weronski** » 6 Jul 2015 2:59 pm

I was just curious because I was having trouble with the C6 neck where some of the strings would not return to pitch because the fingers were hitting the end plate and could not return all the way. So I turned the screws a little bit and it raised the whole changer system so now all of the fingers can return their original positions.

Henry Matthews · Post by **Henry Matthews** » 6 Jul 2015 3:01 pm

Inquiring minds want to know

Henry Matthews · Post by **Henry Matthews** » 6 Jul 2015 3:03 pm

Loosen your strings and tighten them up or you will have bigger problems.
There is something else causing your problem, not those.

Donny Hinson · Post by **Donny Hinson** » 7 Jul 2015 2:58 pm

Not Sure What This is For...

Then it's probably best if you leave it alone. $:\$

Paul Norman · Post by **Paul Norman** » 7 Jul 2015 6:04 pm

You are always right Chris.

Darvin Willhoite · Post by **Darvin Willhoite** » 7 Jul 2015 6:34 pm

Also known as Socket Head Cap Screws, or SHCS's. These go through the wood body and into a threaded hole in the flange on the end plate, sandwiching the wood between the changer plate and the flange on the end plate. The other screws on the changer plate only go into the wood body, so they are phillips head wood screws. As has been already said, don't fiddle with them unless you're totally dis-assembling the guitar.