Potentiometer identification

Jim Palenscar · From: Oceanside, Calif, USA

I'm working on an Ibanez amplifier for a friend and am in need of replacing the treble pot in his Troubadour T35 as well as the input jack. I've had no luck contacting Ibanez about getting replacement parts and it would be easier if I could get exact replacements for the two parts as they are both PCB connected. The attached pic is from the back of the pot in question (a 50k linear pot) and I'm unable to find the manufacturer and was hoping that one of you might be able to identify it by the logo attached. Thanks in advance- Jim

Dave Grafe · From: Hudson River Valley NY

don't recognize the logo Jim, but I've got a mess of PC mount post from Biamp days, I'll see if there are any 50k ones here...

Jim Palenscar · From: Oceanside, Calif, USA

Thanks Dave- these pots are .625" in diameter and there is roughly .200" between the pot and the board. I'm trying to make it the same as it was but realize that I might have to hand wire one- it also has a D shaft.

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: