Tuning at the end plate on an all pull Emmons?

Terry Sneed · From: Arkansas,

I've never tuned an all pull guitar.
once I get the strings tuned open,
which of the hex head screws do I use
for my raises and lowers?
my E to F knee lever sounds flat on the F note. which of the hex screws will raise it
and which will lower. thanks

Jim Bob Sedgwick · From: Clinton, Missouri USA

Terry: On all pull guitars, The upper row of tuners are the raises and the lower rows lower the strings. Count across the top of the changer to the fourth set of tuners. There should be (if you have the standard set up), two tuners, one for the C pedal and one for the E to F Raise. Hope this helps

[This message was edited by Jim Bob Sedgwick on 28 February 2004 at 12:54 PM.]

Terry Sneed · From: Arkansas,

Thanks Jim Bob, I figured it was upper row for raises and lower row for lowers, but wadn't sure.

C Dixon · From: Duluth, GA USA

Deleted,

Because carl put his mouth in gear before his brain got engaged. Sorry bout that,

carl

[This message was edited by C Dixon on 28 February 2004 at 01:40 PM.]

John Fabian · From: Mesquite, Texas USA * R.I.P.

You might find this resource useful:
http://www.steelguitarinfo.com/adjustments/tuneitup.html

John Fabian
www.steelguitar.com
www.steelguitarinfo.com

Terry Sneed · From: Arkansas,

Thanks a lot John. that's what I needed.

Forum Index > Pedal Steel		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: