Need source for Pac-seat legs

Danny Naccarato · Post by **Danny Naccarato** » 7 Jun 2003 7:44 am

Can anyone steer me in the direction to find some legs for a pac-seat???

Thanks,
Danny

Kurt Graber · Post by **Kurt Graber** » 7 Jun 2003 11:17 pm

I looked everywhere for these years ago with no luck. My solution was to go to a surplus metal supply yard and find some round, hollow aluminum stock and cut 3 pieces for each leg side and mig weld them together at 45 degree angles. I have a friend with these tools so he was pretty good at it. Nevertheless; lots of people have these welders, especially race car guys.
I'm sure a metal/welding shop would weld you up some pretty reasonable,I don't know,but it never hurts to ask.

Stephen Gambrell · Post by **Stephen Gambrell** » 8 Jun 2003 4:51 am

UUUHHHHH----ED NAYLOR???????

Wayne Brown · Post by **Wayne Brown** » 8 Jun 2003 5:29 am

if you need just legs we sell them unfinished please email me
thanks
wayne brown
c/o out west pac-seats[This message was edited by Wayne Brown on 08 June 2003 at 06:30 AM.]

Smiley Roberts · Post by **Smiley Roberts** » 9 Jun 2003 10:31 am

Doesn't Duane Marrs have any? I thought I saw a small quantity of them over there,a while back.

------------------
<pre> ~ ~
©¿© It don't mean a thang,
mm if it ain't got that twang.
www.ntsga.com</pre>

Bob Cox · Post by **Bob Cox** » 9 Jun 2003 6:55 pm

I have them and can custom size if needed.