Leg repair ?

Bobby Boggs · Post by **Bobby Boggs** » 28 Nov 2002 10:20 pm

I traded for and old Emmons PP.One leg is loose where it screws into the guitar.There was a thread about the best way to repair this.I can't remember who participated in the thread so my search took me no where.Anyone remember this? Thanks ------------------bb

Jerry Roller · Post by **Jerry Roller** » 28 Nov 2002 10:30 pm

Bobby, check email.
Jerry

johnnyb · Post by **johnnyb** » 29 Nov 2002 11:38 am

jb<font size="1" color="#8e236b"><p align="center">[This message was edited by johnnyb on 04 June 2005 at 06:32 AM.]</p></FONT>

Eric West · Post by **Eric West** » 29 Nov 2002 2:14 pm

On my Pro III, the female threads in the end plate were stripped. There's not much meat on the ends of the legs. I sawed the end off flat, took a bolt that went a little deeper in the threads, welded it on the end of the leg, and ground the hex head smooth. On the 'Bud, there were a lot more threads in the cabinet than there were on the end of the leg. It's worked for mre than 10 years.

There are things called "Time Serts" (tm) that are like helicoils but are thicker and much more solid, and lock in much better. I'm sure a google search would turn up a good source.

Steel galls aluminum when you screw it in and out. A cheap tube of copper looking anti-seize should be used if you take it down a lot.

Bobby Boggs · Post by **Bobby Boggs** » 29 Nov 2002 2:52 pm

My thanks to all.And a special thanks to Jerry Roller who took the time to E-mailed me and explain in depth a great way to do this.------bb

Stephen Gambrell · Post by **Stephen Gambrell** » 29 Nov 2002 7:34 pm

Bobby, here's an idea. Send the Push/pull to me, I'll fix it, and then play it for a couple of years to make sure it's right. OK?

Bobby Boggs · Post by **Bobby Boggs** » 30 Nov 2002 12:27 am

Hum that might work.I offered to sell it to one guy.He said the price was to high.I said OK.If you'll buy it. I'll make the payments for you.He still turned me down.