| Author |
Topic: Nashville 1000 amp. |
Jack Lee
From:
Washington, USA
|
Posted 14 Sep 2012 4:25 pm |
|
| My amp cuts out on me when playing but can be fixed if you hit the left front corner of the amp fairly hard. I have seen others amps with the same problem. I would appreciate any help telling me what can be done to fix this problem. Thanks |
|
|
|
Bill Ferguson
From:
Milton, FL USA
|
Posted 14 Sep 2012 4:34 pm
|
|
| Most probably a cold solder joint somewhere on the chassis. This is a common problem with Peavey's. In fact, every repair made at the factory has a charge to "touch up solder joints" |
|
|
|
Stephen Cowell
From:
Round Rock, Texas, USA
|
Posted 14 Sep 2012 6:37 pm
|
|
don't forget to bypass all loops (volume pedal, effects, pre/pwr etc) with a short guitar cord... those switching jacks get dirty unless used often enough.
You can use De-Oxit/Pro-Gold on them... make sure you get in between the switching parts, though. Business card/matchbook cover with ProGold on it works best.
_________________
Too much junk to list... always getting more. |
|
|
|
Paul Arntson
From:
Washington, USA
|
Posted 15 Sep 2012 8:14 am
|
|
Hi neighbor,
I found the power cable was wiggling loose on my N1000.
I put one of those little P-shaped cable clamps up under there and it helped alot. |
|
|
|
Jack Lee
From:
Washington, USA
|
Posted 17 Sep 2012 8:38 am
|
|
| Thanks to all who provided possible solutions. If I solve the problem, I will let you know what I had to do. |
|
|
|
