Emmons Lightweight Case

Amplifiers, effects, recording equipment, seats, racks, parts, or anything else.
Locked
User avatar
Tommy Dodd
Posts: 578
Joined: 1 Nov 1999 1:01 am
Location: Acworth, Ga., USA (deceased)
Contact:

Emmons Lightweight Case

Post by Tommy Dodd »

An original Emmons factory guitar case that came with a 1968 D10 push/pull. The owner evidently didn't use it long and consequently the case is in very good condition. (Don't know why he replaced the handle but he did!) Is it substantial enough to fly your guitar in.....probably not. But, it weighs 6 - 8 pounds and will be a lot easier on your back for the "around town" gigs for sure. Price $145 plus shipping.



Image


Image


Image
User avatar
Tommy Dodd
Posts: 578
Joined: 1 Nov 1999 1:01 am
Location: Acworth, Ga., USA (deceased)
Contact:

Post by Tommy Dodd »

I need some help from some of you Emmons experts. I have had a couple inquiries about different Emmons guitars this case might fit. Was there a difference in the cabinet sizes over the years of the P/P production. Also, how about the Legrande series. Would those cabinets be about the same in general so that someone could use this lightweight case? Thanks for your "expert" opinions.
User avatar
Mike Wheeler
Posts: 3058
Joined: 18 Oct 2004 12:01 am
Location: Delaware, Ohio, USA

Post by Mike Wheeler »

Tommy, the simplest thing to do is to post the inside dimensions of the case. Then everyone could determine whether their guitar would fit or not.
Best regards,
Mike
Kevin Hatton
Posts: 8173
Joined: 3 Jan 2002 1:01 am
Location: Buffalo, N.Y.
Contact:

Post by Kevin Hatton »

Tommy, Push Pulls are 33" , all Legrandes are 33 1/2". Both 11" wide.
Kyle Everson
Posts: 842
Joined: 20 Mar 2006 1:01 am
Location: Nashville, Tennessee

Post by Kyle Everson »

Some pre-1969 push-pulls were thinner than 11".
Tony Dingus
Posts: 3598
Joined: 24 May 2002 12:01 am
Location: Kingsport, Tennessee, USA

Post by Tony Dingus »

What is this case made out of ?

Tony
User avatar
Willis Vanderberg
Posts: 2389
Joined: 13 Mar 2002 1:01 am
Location: Petoskey Mi

Post by Willis Vanderberg »

All push pulls will fit this case. Even my D-10 Black Rock with a wooden pedal board will fit. The black Rock will not fit the later p/p cases as the pedal board is a bit too wide.
User avatar
Ronnie Tibbitts
Posts: 77
Joined: 11 Jan 2005 1:01 am
Location: Dallas, Georgia, USA

Post by Ronnie Tibbitts »

Take a ride TTT. :D
Glenn Austin
Posts: 687
Joined: 7 Dec 2000 1:01 am
Location: Montreal, Canada

Post by Glenn Austin »

I offered to buy this case and was told it was sold. I would still like to buy it.
User avatar
Tommy Dodd
Posts: 578
Joined: 1 Nov 1999 1:01 am
Location: Acworth, Ga., USA (deceased)
Contact:

Post by Tommy Dodd »

Guitar case is sold.
Locked