Losing effects on left channel on stereo steel amp

Tommy Shown · From: Denham Springs, La.

A couple of days ago I moved my stereo steel amp head and effect rack from the factory rack to an aftermarket rack case. After completing the change over, I began to hook up the cables to their respective connections.Once I had them hooked up I turned on the unit and began to play my steel, I would pull the top left knob to give me my effects through both speakers, at which time I was not hearing what I normally would hear. I am hoping it is something minor like a chord.
Tommy Shown

Rich Hlaves · From: Wildomar, California, USA

Hi Tommy,

I would double check the routing of all the cables. It sounds like you have mono in from your axe then one side of the output is only getting the effects in the FX processor. If one side is connected to a "thru" output accidentally that would cause this.
_________________
On man....let the smoke out of another one.

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: