| Author |
Topic: Rick B6 coverplate screws |
James Inkster
From:
Ukee, BC
|
Posted 21 Aug 2009 9:34 am |
|
Hi,
Does anyone know exactly what size the little machine screws are that hold the coverplates on my mid-40s B6?
I tried some #4 and they were too big... which makes me think "3" but i've been told no such thing exists...wtf?
thanks. |
|
|
|
Ron Simpson
From:
Illinois, USA
|
Posted 21 Aug 2009 2:09 pm
|
|
| "Radio Shack", an electronics store carries number 2 machine screws. You might try a similar store up your way. |
|
|
|
Bill Creller
From:
Saginaw, Michigan, USA (deceased)
|
Posted 21 Aug 2009 5:38 pm
|
|
They are 3-48 screws. I use the 3-48 pan head type, since the original head style is not available anywhere I've looked. Usually 1/2 inch length, but if you have some holes that have bad threads, a 5/8 inch length may grab some better threads down in there a bit farther.
Stainless steel screws of course. You may find some at McMasterCarr web site. |
|
|
|
John Dahms
From:
Perkasie, Pennsylvania, USA
|
Posted 22 Aug 2009 4:08 am
|
|
A few years back I needed some #3 screws for an old National reso coverplate and found a hobby shop that serves model train enthusists was able to order me both screws and a tap. Try searching that route.
_________________
Time flies like an eagle
Fruit flies like a banana. |
|
|
|
James Inkster
From:
Ukee, BC
|
Posted 22 Aug 2009 10:08 am
|
|
| Thanks guys, i think i've found a local source for #3-48! |
|
|
|
Bill Creller
From:
Saginaw, Michigan, USA (deceased)
|
Posted 22 Aug 2009 3:18 pm
|
|
If you don't find them locally, send me your address and I'll send you some. I have lots of them, and the price is right, $00.00  |
|
|
|
