Which lever lowers your E's?

Instruments, mechanical issues, copedents, techniques, etc.

Moderator: Shoshanah Marohn

Where do you lower your E's? (E9 neck)

LKL
27
8%
LKR
169
49%
RKL
117
34%
RKR
31
9%
 
Total votes: 344

User avatar
Eric Philippsen
Posts: 1966
Joined: 14 Jan 2008 5:38 pm
Location: Central Indiana, USA

Post by Eric Philippsen »

When I started, my Sho-bud had the standard RKL for lowering the E's. I played that guitar for decades and it was what I grew used to. Now, I play other steels which lower on the LKR. I often wish they were like my old Bud but, no, I'm not going to switch 'em around, especially on the push-pulls.
Brian Herder
Posts: 428
Joined: 4 Aug 1998 11:00 pm
Location: Philadelphia, Pa. USA

Post by Brian Herder »

My first steel was an Emmons with LKR, so when I ended up with my Sho~Bud, I switched it from their usual RKL.. I went back and forth a couple times, and think I may prefer it on the right, but I am too lazy at this point to switch it again, and either way is fine with me, so for now it's staying LKR.
User avatar
Dave Mudgett
Moderator
Posts: 9648
Joined: 16 Jul 2004 12:01 am
Location: Central Pennsylvania and Gallatin, Tennessee

Post by Dave Mudgett »

RKL.

IMO, the definitive discussion on the issue of F-lever (E=>F raise) vs. E-lever (E=>Eb lower) placement was five years ago on this thread with important contributions by Buddy Emmons and Paul Franklin, who each cogently explained his reasoning for doing this differently - http://steelguitarforum.com/Forum5/HTML/007769.html

I tried every different way and in the end opted for the Paul Franklin approach - F-pedal on LKL, E-lever on RKL. In other words, I put the levers on different legs. Since I sometimes play a universal E9/B6, it made sense to put the E-lever on the right knee so I don't have to hold it in with my left knee while working the standard "B6-mode" pedals with my left foot. If I wanted to put them on the same leg, I'd probably opt to put both changes on the right knee. To me, that rationale would be less compelling if I decided to scrap that universal tuning and move to my D-10s completely.

I think once those decisions are made, different players likely find it more comfortable to choose one direction or another, and Emmons vs. Day setup influences this also. If the F-lever is on the left knee, it makes sense to put it near the A-pedal to facilitate the critical A+F move, so I think Emmons players tend to put it on LKL, Day players tend to put it on LKR. If one decides to put the E-lever on the right knee, either RKL or RKR seem like reasonable choices, and since it's such a heavily used change, it makes sense to put it where it's most comfortable. For me, that's RKL, not RKR. It's much easier for me to move my knee in than out.

Perhaps more than you wanted to know, but I found it useful to think about it like this as I tried out different approaches. I think it also helps to explain why there's so much diversity of approaches among different players. I don't think this decision is made in isolation of other factors.
User avatar
b0b
Posts: 29108
Joined: 4 Aug 1998 11:00 pm
Location: Cloverdale, CA, USA
Contact:

Post by b0b »

RKL for me. And on C6th I raise the E's to F on RKR which is sort of the same movement if you think about it. :mrgreen:
-𝕓𝕆𝕓- (admin) - Robert P. Lee - Recordings - Breathe - D6th - Video
User avatar
Chris LeDrew
Posts: 6404
Joined: 27 May 2005 12:01 am
Location: Canada

Post by Chris LeDrew »

I like that "F to Eb" sweep you can do smoothly when the E raises are on a different leg than the E lowers. I always have a hard time putting that into words, but I use that change in the same way I use the AB pedals (rocking on and off the A), only on the 4-5 strings instead of the 5-6 strings.
Jackson Steel Guitars
Web: www.chrisledrew.com
Brint Hannay
Posts: 3942
Joined: 23 Dec 2005 1:01 am
Location: Maryland, USA

Post by Brint Hannay »

Me too. Not only the F to Eb sweep by itself, but also the smooth move from A+F to Eb lowers, e.g at the third fret E major (A+F) to Bm (E lowers), in any of the three-string chord grips. Also, I like being able to add the A pedal to the Eb-lowers-only position without a relatively contorted left-leg configuration.
User avatar
David Doggett
Posts: 8088
Joined: 20 Aug 2002 12:01 am
Location: Bawl'mer, MD (formerly of MS, Nawluns, Gnashville, Knocksville, Lost Angeles, Bahsten. and Philly)

Post by David Doggett »

What Dave M. just said. And also what Chris and Brint said about the F to Eb sweep. Count me with Mr. Franklin.
Tom Keller
Posts: 657
Joined: 13 Nov 2001 1:01 am
Location: Greeneville, TN, USA

Post by Tom Keller »

RKL
Dean Parks
Posts: 579
Joined: 9 Jul 2004 12:01 am
Location: Sherman Oaks, California, USA

Post by Dean Parks »

Chris-

Good poll. I am RKL, but I did not learn on a Sho-Bud. I converted, and liked the way it felt for "diggin in" kind of playing, and the the Eb-to-F sweep in the AF position (and for min6 to min/maj7).
User avatar
Chris LeDrew
Posts: 6404
Joined: 27 May 2005 12:01 am
Location: Canada

Post by Chris LeDrew »

Dean,

It's interesting that this topic never came up in our conversation in the Rains room last March. It seemed we talked about every lever but the E lowers.

Where do you drop your E's on your 12-string? I seem to recall yours is an extended E9, so I assume you lower them in the same position as your standard E9 guitars.
Jackson Steel Guitars
Web: www.chrisledrew.com
User avatar
Mike Perlowin
Posts: 15171
Joined: 4 Aug 1998 11:00 pm
Location: Los Angeles CA
Contact:

Post by Mike Perlowin »

LKR
Please visit my web site and Soundcloud page and listen to the music posted there.
http://www.mikeperlowin.com http://soundcloud.com/mike-perlowin
User avatar
Bo Borland
Posts: 3947
Joined: 20 Dec 1999 1:01 am
Location: South Jersey -
Contact:

Post by Bo Borland »

RKR - lower
RKL raise
It's what I started with and most comfortable.
User avatar
David Doggett
Posts: 8088
Joined: 20 Aug 2002 12:01 am
Location: Bawl'mer, MD (formerly of MS, Nawluns, Gnashville, Knocksville, Lost Angeles, Bahsten. and Philly)

Post by David Doggett »

Chris, I'm not so sure the sizable minority for RKL is all a holdover from people who learned on an old Sho-Bud. Like many, I've tried it both ways, and decided I much preferred RKL. While modern manufacturers go with LKR to match the majority, I think Paul Franklin and the increasing number of uni players may have started a movement back to the old Sho-Bud standard. If not increasing in use, RKL seems to be holding its own and not about to give way to LKR as a "standard."
User avatar
Chris LeDrew
Posts: 6404
Joined: 27 May 2005 12:01 am
Location: Canada

Post by Chris LeDrew »

David, I think you're correct on the Sho~Bud assessment. The use of the RKL to lower the E's cannot be wholly attributed to that. It's just that most players I've talked to in person said that their first guitar was a Sho~Bud and it came with that configuration, and they just got used to it.

If the gap between LKR and RKL users is not really that wide, I wonder why practically no steel builders at the shows have a guitar on display that lowers on the RKL? Carter usually has one or two, because they have a lot of steels on the floor. But most others may have one that lowers on the RKL, if at all. Coming back from St. Louis or Dallas, I almost have to get back into the swing of the RKL again, after playing all the floor steels! :)
Jackson Steel Guitars
Web: www.chrisledrew.com
User avatar
Nic du Toit
Posts: 1626
Joined: 20 Feb 2000 1:01 am
Location: Milnerton, Cape, South Africa
Contact:

Post by Nic du Toit »

RKL
1970 P/P Emmons D10 flatback 8x5, BJS Bar, J F picks, Peavey Session 500, Telonics pedal. Boss GX700 effects.
Skype : nidutoit
User avatar
Dave Hopping
Posts: 2221
Joined: 28 Jul 2008 4:18 pm
Location: Aurora, Colorado
Contact:

Post by Dave Hopping »

RKL.
User avatar
Paddy Long
Posts: 5462
Joined: 19 Aug 2003 12:01 am
Location: Christchurch, New Zealand

Post by Paddy Long »

Good point Chris ...for this very reason I don't usually spend a lot of time playing on guitars that don't have the RKL setup ... so maybe the manufacturers (other than Carters) should have an example of both available at their booths!!
14'Zumsteel Hybrid D10 9+9
08'Zumsteel Hybrid D10 9+9
94' Franklin Stereo D10 9+8
Telonics, Peterson, Steelers Choice, Benado, Lexicon, Red Dirt Cases.
Bob Farlow
Posts: 1083
Joined: 4 Aug 1998 11:00 pm
Location: Marietta,GA,

Post by Bob Farlow »

Lower RKR
Raise RKL
User avatar
Bob Blair
Posts: 2623
Joined: 15 Jul 1999 12:01 am
Location: Edmonton, Alberta, Canada

Post by Bob Blair »

RKL, but I've had it on LKR from time to time and don't have a lot of trouble switching back and forth.
Terry Sneed
Posts: 4643
Joined: 17 Feb 2004 1:01 am
Location: Arkansas,

lower E's

Post by Terry Sneed »

I lowered my Es on RKL years ago, but for the last 10-15 years I lower them on LKR.

Terry
1997 emmons legrande lll 8&5/ Nashville 112 with Fox chip mod LTD 400 / American Tele / John Jorgerson Takamine/ W/S Rob Ickes model dobro/
"May God Bless America Again"
User avatar
Marke Burgstahler
Posts: 136
Joined: 7 Nov 2008 4:56 pm
Location: SF Bay Area, CA

Post by Marke Burgstahler »

RKL here. I was having some issues using the pedals when my LKR did it...and a wonderful Mr. Tom Bradshaw suggested I give it a try on the RKL - works great for me.
"It Don't Mean A Thing If It Aint' Got That Swing"
Roual Ranes
Posts: 1344
Joined: 18 Jun 2004 12:01 am
Location: Atlanta, Texas, USA

Post by Roual Ranes »

A guy I know up here, had a "student" model with E's lowered on LKR. He bought an MSA D-10 that had the E's lowered on RKL. He really likes it that way. He says the V7 is a lot easier to reach.
I've tried the LKR and don't like it.
Ray Kedge
Posts: 189
Joined: 5 Dec 2007 4:14 pm
Location: Middlesex, England

What Lever Lowers your E's

Post by Ray Kedge »

A lot of players in the UK have the Day set up thanks to Gordon Huntley who was the main man of the time and he set up the guitars in the shop the same way as himself.So I think we all have LKL for lowering the E's.But I would certainly consider RKL even with the Day set up.



Ray
User avatar
John Polstra
Posts: 335
Joined: 29 Dec 2008 3:11 pm
Location: Lopez Island, WA, USA
Contact:

Post by John Polstra »

I think I'm missing something, because I can't understand why folks would use anything except LKR to lower the Es on an E9/B6 uni. Here's my reasoning:
  • The knee that is holding the Es lowered is out of commission for anything else. It can't operate another knee lever.

    When using the B6 foot pedals, the left foot is way over to the right, making it impractical to use the left knee for anything except holding the Es lowered with LKR.

    Therefore, if you lower the Es with your right knee, you have no B6 knee lever available at all. Whereas if you lower the Es with LKR, you can still use your right knee as the normal B6 knee lever.
What am I missing?

John
Post Reply