| Author |
Topic: USB question |
winston
From:
Frankfort, Kentucky 40601
|
Posted 31 Mar 2009 6:08 am |
|
| Is there any way to convert a 1.3 USB to a 2.0 without changing the motherboard? I have a pci card with USB connectors on it and I cannot get a 2.0 driver. I am using winxp pro. I cannot find any info on this. thanks Winston May |
|
|
|
John Gould
From:
Houston, TX Now in Cleveland TX
|
Posted 31 Mar 2009 6:21 am
|
|
If your pci card is not made to be USB 2.0 to begin with you need to buy a different card. It's more than just a driver issue.
_________________
A couple of guitars
Fender GTX 100 Fender Mustang III Fender Blues Jr. Boss Katana MKII 50
Justice Pro Lite and Sho Bud Pro II |
|
|
|
Wiz Feinberg
From:
Mid-Michigan, USA
|
|
|
|
winston
From:
Frankfort, Kentucky 40601
|
Posted 31 Mar 2009 8:22 am
|
|
| thanks for the info. I had been under the impression that all USB pci cards were 2.0. thanks again Winston |
|
|
|
Wiz Feinberg
From:
Mid-Michigan, USA
|
Posted 31 Mar 2009 12:25 pm
|
|
| winston wrote: |
| thanks for the info. I had been under the impression that all USB pci cards were 2.0. thanks again Winston |
The original spec, around 1996, was 1.0, then a little later, circa Win 9x, 1.1, then later, 2.0. If your motherboard only supports USB 1.x, it must be very old and out-dated.
_________________
"Wiz" Feinberg, Moderator SGF Computers Forum
Security Consultant
Twitter: @Wizcrafts
Main web pages: Wiztunes Steel Guitar website | Wiz's Security Blog | My Webmaster Services | Wiz's Security Blog |
|
|
|
